ICOM 200 Manual do Utilizador descarregar pdf (Página 37)

ICOM-241

RUN mode

If the DIP-switch “PC/Run” is in position “Run”, the program in the ICOM-241

is executed immediately after a reset. Debugging is not possible in this mode.

Program download

A program created with the Tiger software is downloaded into ICOM-241

through the 9-pin Sub-D connector. To download the following has to be done:

Connect a power supply 8-12 V DC (Polarity: Inner contact = minus,

outer contact = plus)

Connect ICOM-241 and PC with 9-pin D-Sub cable

Set DIP switch of ICOM-241 to PC mode

Set the reset DIP switch to „Reset“ and back to original position

Start download at the PC.

Serial port 1 / Download DB-9 plug

TXD 2

RXD 3

GND 5

Wilke Technology GmbH • 0241/918900 • http://www.wilke.de/ • [email protected] 3-3

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 54 55

Sem comentários

ICOM 200 Manual do Utilizador Página 37