ICOM 200 Manual do Utilizador descarregar pdf (Página 10)

ICOM-manual

First steps

Power supply

The ICOM-200/201 uses a power supply with 8-12 VDC, 1A. Minus is placed

on the pin of the power supply connector. The current consumption is,

depending on the application, up to 400mA.

PC mode

After a reset or power-down the Tiny-Tiger

inside the ICOM-200/201 is

testing if the PC mode pin is „low“. In this case, the ICOM switches to PC

mode/Debug mode. Is the pin „high“, the ICOM starts in run mode. The time

between power-on and first activity on the I/O pins is approx. 230 msec.

To set the ICOM-200/201 to PC mode, a reset or power-down is needed.

Setting the DIP switch to PC mode while in run mode is not sufficient.

2-2

Wilke Technology GmbH • 0241/918900 • http://www.wilke.de/ • [email protected]

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 54 55

Sem comentários

ICOM 200 Manual do Utilizador Página 10